Pressure Washer Maintenance Guide

Support needs differ between pressure washers, yet fuel controlled models for the most part require more upkeep than electric models. Some upkeep requires the compel washer to be running. Check the proprietor's manual for a support plan and itemized steps to keep your pressure washer running its best. Star Tip: Never work a fuel controlled pressing factor washer inside or in a space without appropriate ventilation. While working an electric pressing factor washer, keep the electrical associations get and dry the ground. Try not to contact the attachment if your hands are wet.

• Check the oil and fuel levels on gasoline-powered models; don't overfill.
• Check the water inlet screen, located where you connect the hose . Clean dirty screens with water, or replace it if damaged.
• If your pressure washer is provided with an inline screen within the wand extension, confirm it isn't clogged. Clean it with water, or replace if damaged.
• Inspect the applicator , wand extension and spray tip. confirm the connections are secure, including the connection to the high-pressure hose.
• Test the applicator trigger and trigger lock. If they do not function correctly, replace the applicator .
• Examine the high-pressure hose for cuts, leaks, bulges or other damage, check the hose couplings. If the hose is broken , read the manufacturer's replacement instructions.
• Check the detergent siphoning tube and clean it out if it's clogged. If the detergent system features a filter, check it also .
• Flush out the hose you will be connecting to the pressure washer.
• After employing a Pressure Washer
• Electric Pressure Washer.
• After you finish your cleaning project, it is time to properly store your pressure washer:
• Rinse detergent from the pressure washer. Remove the detergent siphoning tube from the detergent supply and set the spray to low . Run water through the system for one or two minutes.
• Relieve pressure within the machine. close up the pressure washer and therefore the water system . If you've got an electrical pressure washer, unplug it from the wall socket . Point the applicator faraway from any people or animals and run it until the water stops flowing.
• Engage the trigger lock and let the pressure washer calm down .
• Disconnect the hose , spray gun, wand extension and high-pressure hose. Drain water from them.
• Remove any remaining water from the pump. If you've got gasoline-powered model, pull the recoil handle about sixfold . If you've got an electrical model, turn the unit on until the water exits the pump then turn it off immediately.
• Clean off any debris.